Dfi NP951-B16C Uživatelský manuál stáhnout pdf (Strana 61)

BIOS Setup

IDE HDD Block Mode

Enabled

The IDE HDD uses the block mode. The system BIOS will check the hard disk

drive for the maximum block size the system can transfer. The block size will

depend on the type of hard disk drive.

Disabled

The IDE HDD uses the standard mode.

IDE DMA Transfer Access

This eld is used to enable or disable the DMA transfer function of an IDE

hard drive.

On-Chip Primary PCI IDE

This eld allows you to enable or disable the primary and secondary IDE con-

troller. The default is Enabled. Select Disabled if you want to add a different

hard drive controller

IDE Primary Master/Slave UDMA

These elds allow you to set the Ultra DMA in use. When Auto is selected,

the BIOS will select the best available option after checking your hard drive

or CD-ROM

Auto

The BIOS will automatically detect the settings for you.

Disabled

The BIOS will not detect these categories.

SATA Mode

IDE

This option congures the Serial ATA drives as Parallel ATA storage devices.

AHCI

This option allows the Serial ATA devices to use AHCI (Advanced Host Con-

troller Interface).

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 128 129

Žádné komentáře

Dfi NP951-B16C Uživatelský manuál Strana 61