Dfi ES121-LR Uživatelský manuál stáhnout pdf (Strana 55)

Ports and Connectors

IDE Connector

Important:

WedonotrecommendusingIDEdevicesandCFcardatthesametime.

The IDE connector is used to connect hard drives. The connector on the IDE

cablecanbeinsertedintothisconnectoronlyifpin1ofthecableisalignedwith

pin1ofthisconnector.

The IDE connector supports 2 devices, a Master and a Slave. Use an IDE ribbon

cable to connect the drives to the system board. An IDE ribbon cable have 3

connectors on them, one that plugs into the IDE connector on the system board

andtheother2connectstoIDEdevices.Theconnectorattheendofthecableis

fortheMasterdriveandtheconnectorinthemiddleofthe cableis forthe Slave

drive.

Note:

Refer to your disk drive user’s manual for information about selecting

properdriveswitchsettings.

Adding a Second IDE Disk Drive

Whenusing two IDEdrives,one mustbeset as themasterand the otherasthe

slave. Follow the instructions provided by the drive manufacturer for setting the

jumpersand/orswitchesonthedrives.

The system board supports Enhanced IDE or ATA-2 and ATA/33 hard drives. We

recommendthatyouuse hard drives from the same manufacturer. In a few cas-

es, drives from two different manufacturers will not function properly when used

together.Theproblemliesintheharddrives,notthesystemboard.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 174 175

Žádné komentáře

Dfi ES121-LR Uživatelský manuál Strana 55